11/18/2023 0 Comments Tower pro mag 8 esc brake instructionsÂ-† Automatically select NiMH, the protective voltage for each battery is 0.8V. Â-† Automatically select 2-3LiPo,protective voltages are 6V/9V respectively See if you have any luck with it.ġ2A: max current 15A, continuous current 12A for 10 minutesĢ5A: max current 30A, continuous current 25A for 10 minutesģ0A: max current 35A, continuous current 30A for 10 minutesīEC Output: 5V1.5A.2LiPo\4-5mini servo, 3Lipo\3-4mini servo I am yet to try but it seems to match what i have been hearing from the esc. I have been searching the net and think i have finally found what we need. I have been having the same issues with a Mag 8 esc that i have no instructions for. When all you need option is setup OK, push the throttle stick to down position, after 1sec the system were save all option, then you can start the motor now!! and the system will go to the programming menu. IF the option is you need, then move the throttle stick to UP position. *IF used 2LIPO you can use the option (select the NiMh/Nicd AUTO) ON you need programming menu, move the throttle stick to the middle position Reconnect battery power to the speed controllerĪfter 3sec you can hear (all sound is 3times) Move throttle stick on full power position, (UP Position) Remove battery power from the speed controller. Type Current Fe t BEC Timing mode PWM LIPO NIHMĤ0-N 40A/60A 18 5V/4A 3/8/15/30 8/16/32K 2to5 6/18Ħ0-N 60A/80A 24 5V/4A 3/8/15/30 8/16/32K 2to5 6/18ĥLIPO or 18 cells NIMh/NiCd MAX with BEC disabledįirst, connect the motor and receiver to the speed controller Not the exact same controler but try this Also an e-bay esc
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |